ATR Tile Leveling Alignment System Cross Spacers 100 Pieces 3mm

Apex Coverage Area per 100 spacers - about 100 sq ft

Grout spacer 3mm - Tile thickness 15/64 - 51/64 (1/4 - 3/4) (6mm-20mm)

This Tile Leveling system is a 2 part system (Spacers And Spindles) and does not require the use of additional, expensive tools. 

The ATR leveling system also available  in 3 ready made kit sizes or can be costume ordered for individual quantities depending on the coverage areas.

The DIY Start-up Kit: 40 Cross Spacers, 20 Edge Spacers, 60 (Re-Usable) Spindles - For About 60 sq ft coverage area.

The DIY Kit: 100 Cross Spacers, 50 Edge Spacers, 100 (Re-Usable) Spindles - For 190 sq ft coverage area.

The ATR Pro 500: 500 Cross Spacers, 100 Edge Spacers, 200 (Re-Usable) Spindles - This kit is for about 570 sq ft coverage area.

Buy Now From A2Z Sell

Go lippage free in your tile installation. Tiles that may seem perfectly leveled during installation, after the thinset cures, often show a difference in height which can compromise the aesthetics. Accurate tile setting requires perfect leveling of the tiles and it is often hard to properly set ungauged and thin tiles as well as larger and thicker tiles because of uneven floor foundations.

In Stock Ship Same Day

To Order  Visit Us On www.a2zsell.com or Call 818-9750488 

Advantages of the ATR Tile Leveling

• No Tools (GUN) needed! No need for expensive hand tools.
• Simple and quick to lay with only 2 elements: Spacer & Spindle.
• The only system that removed without the use of a force
• Only System that leave clean grout line (no risk of spacers not break all the way)
• Cross Spacers (+) Shape allow for 2/3 of saving
• Creates a lippage free surface
• Keeps tiles in place while drying
• All-in-one grout spacing and tile alignment system
• Stress free installatio
• Saves time
• Suitable for floors and walls
• Re-usable spindle
• Australian design and Australian made

How to use 3 Easy steps

1. Spread thinset install tile

2. Screw spindle into spacing plate, Slide spindle with spacing plate attached in between two tiles.

3. Tighten spindle clock wise firmly until all four corners are aligned flush.
* Remove Re-usable spindle once tile adhesive is dry.